Archive for the ‘Building a Shed’ Category
im building a storage shed and want a gambrel roof?
the shed will be 12x 12 with the walls 96 inches this is with top plates and bottom plate. im having a bit of trouble finding the length to cut my trusses and also trouble with the angles to be cut. i have built a shed with a gable roof in the past.
you are essentially building a roof with 2 pitches. place your ridge. determine what you want for the front pitch, figure your cuts with a swanson square or roofing square, and do the same for the different pitch on the back.
how do you cut a truss without it falling apart? if you are building your own trusses, that takes a lot of engineering to produce the proper load bearing. did you mean rafters?
Hope that helps.
Eletricians can you tell me the correct depth to lay armoured cable to a shed please?
I am taking power to an new build shed I just reqire the depth to lay the armoured cable. Please note I was a semi skilled electrician and connection will be done by an niec approved engineer Regards SJ
over 500mm measured from the TOP of the cable.
timelapse garden shed build
timelpase video of my father and me building his new garden shed. taken over 3 days in October 2007
Duration : 0:3:40
Building a shed no more than 120 sq ft how do I make a foundation that will allow the building to be moved..?
Just in case I decide to move.
I would use 4×4 skids. That way when you move it, it can just be slid onto a flatbed trailer and off you go.
Building my shed during my week off of work.
I want to buy 4×8 vinyl panels To use for building a shed About 1 to 2 Inches thick?
4×8 ft vinyl panels only come in 1/4 in. i have never heard of it coming in 1 in. the only thing that I can think of is to glue it on to plywood. put the plywood on then glue the vinyl on to it
How much concrete will I need for this shed?
The shed is going to be 120 " x 140 " and I guess like 4 " thick. Home Depot has 80lbs bags for like 5$ a pop so how many do you guys think i would need? Also, When laying the foundation should the concrete be like 2 " under the ground and 2 " above ground or is 4 " too think all together. I have built sheds in the past but never layed a concrete foundation. Just want to build my dad a really nice one while he is gone on a work trip.
I wondering why you want a a solid slab for a shed. Is this going to be stick-built by hand or purchased, delivered and set in place? I’ve done sheds that merely rest on concrete piers with floor framing. You save on money, materials, labor and time by propping up the structure on pads and piers. Plus,the structure is higher off the ground to avoid rot from the elements and bug infestations.
Go to the Sakrete website and use their online materials calculator at: http://www.sakrete.com If you’re going the solid slab route, you should consider forming and pouring short stub walls to raise the structure above grade. This could also be done with CMU’s laid on top of the cured slab with mortar. Remember to prep the slab area with plenty of tamped gravel or stone dust and let any excavated dirt settle before pouring concrete. Use reinforcing wire mesh in your slab or rebar and be sure to damp cure the pour for a week or so with a burlap cover and an occassional sprinkler to keep the concrete damp.
Hauling and mixing bags to a pour is a hassle. You should check out your local redi-mix company for a price quote and a delivery. Trust me…it’s great when a truck loaded with redi-mix drives up to your pour and you’e done with the whole mesh in about 10 minutes. It’s worth the extra money!
Good luck
Building A Clerestory Shed
A step-by-step visual of building a Clerestory Shed or project plan, featured in, The Complete Guide To Contemporary Sheds Book or projectplans.com
Duration : 0:1:8
Shed Building Plans – Do I Need a Permit to Build a Backyard Shed?
Normally, you don’t need a permit if the shed is less than 100 sq ft in floor area. The same applies for minor construction & on-site repairs.
However, you must comply with the construction codes of your area, including the Zoning Ordinance requirement for setbacks.
A well laid-out shed plan (or plot plan) will help you get the Council’s approval, if required.
Part 11 – Building a shed from gardensheds.com.au
Door Boxing & Seals – How to attach door boxing and seals to your garden shed from gardensheds.com.au
Duration : 0:0:45